I gather that I connect the motor’s four wires to the two screw terminals, where the two wires from one coil connect to the terminals labeled “motor a” and the two wires from the other coil connect to the terminals labeled “motor b”. This is very affordable small fan for s.. No shipping charges on all of your order. The truth table for a single HG L chip is as follows: These chips have built-in output clamp diodes to protect your sensitive microcontroller electronics.

Uploader: Gardadal
Date Added: 15 September 2015
File Size: 26.23 Mb
Operating Systems: Windows NT/2000/XP/2003/2003/7/8/10 MacOS 10/X
Downloads: 87402
Price: Free* [*Free Regsitration Required]

There’s a problem loading this menu right now. The truth table for a single HG L chip is as follows: Fingerprint Reader Integrated SM Amazon Restaurants Food delivery from local restaurants. Please try again later.

The board has 6 male pins and 2 double terminals. For warranty information about this o9110s, please click here. Share Facebook Twitter Pinterest. Do you think it would be possible to control this driver with a joystick? More then enough for a small DC motor.

Related Drivers  EMX MCP61M ICAFE DRIVER

L9110S Dual-Channel H-Bridge Motor Driver Module

Using a PWM signal on the input will definitely stress the IC beyond its recommended operating parameters. Hookup instructions are provided by the comments.

Banana Robotics has a wide range of motor drivers l9110e intelligent controllers to choose from.

Image Mmotor Image not available for Color: Leave a Reply Click here to cancel reply. Wiring it up incorrectly to the motor. Don’t see what you’re looking for?

LS Dual-Channel H-Bridge Motor Driver Module Philippines | Makerlab Electronics

Amazon Inspire Digital Educational Resources. Thank you I almost fried my board do you have a schematic or diagram for this project with IR added also? Martin French part St.

One I downloaded I don’t know from where is not the manufacturers, but says: Add to Cart Details. This low ampere motor driver should fit your project!

The documentation and many, many tutorials on the internet mention that this can be used to drive two DC motors, or a signle bipolar stepper motor. It provides mA of continuous output current when powered. Attach Image Upload File. You could use the Arduino Stepper class which uses ‘half-stepping’. You only have to supply it one voltage between 2. Email to a Friend. What are left and Right for? Alexa Actionable Analytics for the Web.


Unfortunately, every bit of documentation or article I can find only provide examples on how two drive one or two DC motors, but nowhere can I find how to drive a stepper motor.

So you don’t need to use PWM pins if that Stepper class is all you want to use. It would probably draw too much current, and hooking inductive loads directly to electronic controls without special provisions is not a good idea in general. Here is the sketch to test the module with 2 small DC motors:.

Please try your search again later.